fbpx
|

6100 Truck

CLASS 6100
Unlimited Truck-Limited Engine

Click here to download a PDF.

DEFINITION
Unlimited 4 wheel, 2 wheel drive vehicles. Vehicles must have a production appearing Utility or Sports Utility body. Engines limited to approved sealed engines as supplied by M400 engine suppliers. See M400 engine builders list.

GENERAL REGULATIONS
Entrants in this class shall comply with all applicable general regulations.

TECHNICAL REGULATIONS
This class is an open class and all components will be considered open unless restricted herein.

NOTE: The TR abbreviations listed under this class (I.E. TR1 HELMETS) refer to TR cross reference listings in the front of this book. These TR cross-referenced listings are part of the class rules. Where a conflict occurs between the TR cross-referenced listing and a rule contained under this class, the rule contained under this class takes priority.  Click here to view the TR cross-referenced listing.  

SAFETY EQUIPMENT

TR1 HELMETS
TR2 PROTECTIVE CLOTHING
TR3 EYE PROTECTION and DENTURES
TR4 HEAD AND NECK RESTRAINTS
TR5 FIRST AID KIT
TR6 EMERGENCY SIGNALING DEVICES
TR7 HORNS
TR8 REFLECTORS
TR9 FIRE SUPPRESSION EQUIPMENT
TR10 SURVIVAL SUPPLIES

SUSPENSION COMPONENTS

TR11 SHOCK ABSORBERS and BUMP STOPS
TR12 SECONDARY SUSPENSION
TR13 WHEELS and TIRES
Maximum tire size is thirty seven (37) inches.

TR14 FASTENERS

STEERING and BRAKE COMPONENTS

TR15 STEERING
TR16 BRAKES

ELECTRICAL SYSTEM

TR17 IGNITION
TR18 BATTERIES
TR19 LIGHTS
TR20 STARTERS

FUEL SYSTEM

TR21 FUEL
TR22 FUEL TANKS
TR23 FUEL FILLERS LINES, VENTS, and CAPS
Fuel cell mandatory.

ENGINE, TRANSMISSION and DRIVELINES

TR24 ENGINE and ENGINE DISPLACEMENT
Engine is limited to a sealed V8. Only the following engines are permitted; General Motors LS3 430 HP 19301326, or 19370416. Must use LS3 engine control kit 19258270, or 19354328.

Ford 5.0L V8 engine part number M-6007-M50C. Must use engine control kit M-6017-M50B

Ford 3.5 Ecoboost engine. Must use engine control kit M-6000-35TK.

Ford 351 V8 part number M-6007-S374W.

Engines must be obtained and sealed by a M400 approved engine supplier.(see M400
approved engine builder list)

All engines restricted to stock wet sump oil pans. Oil pans may be modified for fit. No dry
sump oil systems allowed.

All engines may use aftermarket fuel rails.

Any water pump, alternator, power steering pump may be used.(No electric water
pumps)

Oil accumulators are allowed.

Any manufacture wiring loam may be used.

TR25 ENGINE REPLACEMENT
TR26 TRANSMISSION
Turbo 400 transmission only. Any aftermarket case allowed.
No under/over drives allowed.
Must use ford nine(9) inch style rear differential.

TR27 THROTTLES
If engine is supplied with an electric throttle body a fly by wire throttle pedal must be used.

TR28 EXHAUST
TR29 DRIVE SHAFTS
TR30 FLYWHEEL SHIELDS
TR31 FLUID COOLERS
TR32 AUXILIARY EQUIPMENT
TR33 SUPERCHARGERS and TURBOCHARGERS

VEHICLE SAFETY EQUIPMENT

TR34 ROLL CAGES
TR35 SAFETY HARNESS
TR36 SAFETY NETS
TR37 SEATING
Must have a minimum of two (2) seats. Three (3) seats may be used with pre approval of M400 technical.

GENERAL VEHICLE COMPONENTS

TR38 DRIVERS COMPARTMENT
TR39 DOORS AND LATCHES
TR40 FIREWALLS
TR41 BALLAST
TR42 WEIGHT
TR43 FLOORBOARDS
TR44 BUMPERS and HAZARDOUS PROTRUSIONS
TR45 MIRRORS
TR46 SKID PLATES
TR47 STORAGE
TR48 CHASSIS and BODY
Wheelbase and track width are open.
Must use straight axle rear suspension.
Body must appear as a utility or sports utility body. Bodies are subject to M400 approval.

TR49 HOSES
TR50 IDENTIFICATION MARKINGS
M400 will assign race numbers.

TR51 ADVERTISING on VEHICLES
TR52 RADIO EQUIPMENT
TR53 WORKMANSHIP
TR54 TRACKING DEVICE